How to operate the carbon powder molding machine correctly

How to properly operate the charcoal briquetting machine (carbon powder forming machine) is the key to the machine and the finished product. We must pay attention to several aspects when operating the charcoal briquetting machine, in order to make the quality of the carbon rod better and the output higher. The price is also far beyond the general mechanism carbon price.

        1. The surface is cracked. If the raw material moisture is too large, it will easily cause transverse cracks on the rod during production. When the water goes to Europe, it will cause longitudinal cracks. In addition, if the heating temperature is too high, the raw material is excessively softened, thereby causing insufficient supply. This can also lead to cracks. Generally, the problem of insufficient supply is to increase the diameter of the spiral or to polish the spiral wall and increase the span between the spirals.

        2. The density at the center of the rod is small or contains scattered sawdust. This is because the diameter of the root of the tip of the propeller of the carbon powder molding machine is not thickened by welding. Misalignment of the shaft tip can also cause the above problems, which need to be corrected at high temperatures.

        3. The ups and downs show the gas ejected from the feed opening in the production, mainly due to insufficient supply, and may also be due to excessive moisture in the raw materials and insufficient heating temperature.

        4, "smuggling car" raw materials mixed with large particles and hard impurities, or heating temperature is low. The former needs to be shut down for disassembly to remove impurities. Or continue to heat and soften the raw materials.

        There are also many safety hazards in the molding process. First of all, the body of the carbon powder molding machine mainly has a steel material with good electrical conductivity. Therefore, it is best to install a leakage switch at the power supply.